SP-58-2009 incorporates contents of ANSI/MSS SP-69-2003, MSS SP-77-1995 (R 2000), MSS SP-89-2003, and SP-90-2000. This comprehensive Standard Practice combines all the content of five Pipe Hanger and Support standards into a single document. 1/4 inch to mm.

MSS SP-58-2009 will serve as a complete guide for pipe hanger and support design.ANSIMSS SP-58-2009 Pipe Hangers and Supports - Materials, Design, Manufacture, Selection, Application, and Installation This document has been.

MSS SP-58-2009 will serve as a complete guide for pipe hanger and support design, manufacture, selection, and installation; enabling the user to specify a minimum level of acceptance for pipe hanger design and performance, in addition to defining the types of hangers and supports.

20 Oct 2011 The Manufacturers Standardization Society (MSS) announces that revised Standard Practice, SP-55-2011, Quality Standard for Steel Castings for Valves, Flanges, Fittings, and Other Piping Components - Visual Method for Evaluation of Surface Irregularities, has been has been published AND approved by the American National Standards Institute (ANSI) as an American National Standard (ANS). They also approved Standard Practice, SP-58-2009, Pipe Hangers and Supports –Materials, Design, Manufacture, Selection, Application, and Installation. SP-55-2011, utilized for the visual evaluation of surface irregularities in steel castings for valves, flanges, fittings, and other piping components, was originally published in 1961 and is today referenced in many standards’ publications and employed through-out the Industry. On August 26, ANSI granted final approval of the revised MSS SP-55-2011 as an ANS. This Standard Practice is being published in its traditional book format (with improved spiral binding) and in a newly created electronic version (PDF).

The new ANSI-approved American National Standard edition, ANSI/MSS SP-55-2011, is now available and is used extensively in the chemical, petro-chemical, nuclear, boiler and pressure vessel, and other corrosive and high temperature industry environments. This standard establishes the following: (a) Visual surface irregularity acceptance standards for steel parts; (b) Supplements requirements in identified ASTM Standards; (c) Provides a series of referenced photographs typical of the various surface irregularities; and (d) Identifies what is of generally acceptable and generally rejectable quality. Standard Practice, SP-58-2009, Pipe Hangers and Supports –Materials, Design, Manufacture, Selection, Application, and Installation, has also been approved by the American National Standards Institute (ANSI) as an American National Standard (ANS). SP-58-2009 was originally published in 1959 and is an established industry standard to assist and guide those tasked with the design, manufacture, specification, use, and inspection of pipe hangers, systems, and supports. In 2009, SP-58 was revised to comprehensively combine all of the content of five Pipe Hanger and Support standards into a single document.

On February 11, 2011, ANSI granted final approval of MSS SP-58-2009 as an ANS. ANSI/MSS SP-58-2009 includes all of the information from ANSI/MSS SP-69, Selection and Application; MSS SP-77, Guidelines for Pipe Support Contractual Relations; MSS SP-89, Fabrication and Installation Practices; and MSS SP-90, Guidelines on Terminology for Pipe Hangers and Supports.